Direct Drive:
Retraction Distance: 1mm
Retraction Speed: 20mm/s
Indirect Drive:
Retraction Distance: 3mm
Retraction Speed: 40mm/s
Drying Settings: 80˚C for 12h
(Only if the material has absorbed moisture)
PolyDissolve™ S1 is a PVA based water dissolvable support for PLA, TPU, PVB and Nylon based filaments from our portfolio. It is specifically engineered to have a perfect interface with these materials while also displaying good solubility.
PolyDissolve™ S1 can support PLA, PVB, TPU and Nylon based materials from our portfolio.
Printing Temperature: 215˚C - 225˚C
Bed Temperature: 25˚C - 60˚C
Printing Speed: 30mm/s - 40mm/s
Fan: ON
PolyDissolve™ S1 is very hygroscopic, please make sure to use a dry box.
It can take 6-12hours to fully dissolve depending on your setup.
You can speed up the process:
- By increasing the water temperature
- By changing the water regularly
- By adding a pump to make the water flowing
0.75kg cardboard spool:
Spool Inner Hole Diameter: 55±1mm
Spool Diameter: 200±1mm
Spool Width: 50.6±2mm
Spool Weight: 125±7g